Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983MIRADA 3.7 HREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMELECTRONIC FUEL CONTROL SYSTEMREMOVAL & INSTALLATIONSPARK CONTROL COMPUTERNOTES
1983 Dodge and Ram Mirada 3.7 H
Spark Control Computer: Notes
1983 Dodge and Ram Mirada 3.7 HSECTION Notes
NOTE:
DO NOT
remove grease from either harness connectors or connector cavities in computer. The grease is used in order to prevent moisture from corroding the terminals. If there is not at least 1/2" of grease on bottom of computer connector cavities, apply a liberal amount of Mopar multipurpose grease No. 2932524
(or equivalent) over entire end of plug before reinstalling.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.