SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1983600 BASE, 2.6 GREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMELECTRONIC FUEL CONTROL SYSTEMIGNITION SYSTEM STARTING TEST TEST
1983 Dodge and Ram 600 Base, 2.6 G

Ignition System Starting Test Test

1983 Dodge and Ram 600 Base, 2.6 GSECTION Ignition System Starting Test Test
  1. Remove coil wire from distributor cap. Hold end of wire 1/4" away from good engine ground. Have assistant crank engine, while you watch for spark at secondary wire. Spark should be constant and bright blue.
  2. If there is a good spark, continue cranking engine while slowly moving secondary wire away from ground. Look for arcing at coil tower. If arcing occurs, replace coil. If spark is weak or not constant, or if there is no spark, proceed to "Failure to Start Test".
  3. If spark is good and there is no arcing at the coil tower, secondary voltage is satisfactory. Make sure it is reaching spark plugs by checking distributor rotor, cap, spark plug wires and spark plugs.
  4. If all of these components check okay, ignition system is not at fault. Check fuel system or mechanical engine damage.
CAUTION: Perform "Ignition System Starting Test" first. Failure to do so may result in lost diagnostic time or incorrect results.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.