Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1982MIRADA 3.7L ENG VIN EREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSELECTRONIC FUEL CONTROLTESTINGELECTRONIC EGR SYSTEM TEST
1982 Dodge and Ram Mirada 3.7L Eng VIN E
Electronic EGR System Test
1982 Dodge and Ram Mirada 3.7L Eng VIN ESECTION Electronic EGR System Test
NOTE:
The engine temperature sensors must be working properly before performing this test.
- With the engine temperature cold and ignition switch off, connect a voltmeter between Gray wire on EGR solenoid and ground. Start engine. Voltage should read less than 1 volt. This reading should be maintained until normal operating temperature is reached and specified time has elapsed as shown in EGR and Throttle Control Specifications table.
- After normal operating temperature is reached and time has elapsed, voltmeter should register charging system voltage. If voltage readings are not obtained as outlined, replace EGR solenoid and repeat test. If the voltmeter indicates charging system voltage prior to elapse of specified time, replace computer.NOTE: If an engine is restarted while still at normal operating temperature, the voltmeter reading should register 1 volt for the specified time, then register charging system voltage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.