Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1977RAM WAGON B300, VAN PASSENGER EXTENDED, 7.2L ENG VIN DREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGAIR CONDITIONING SERVICINGCOMPRESSOR REPLACEMENTCOMPRESSOR ISOLATION METHODREMOVAL
1977 Dodge and Ram Ram Wagon B300, Van Passenger Extended, 7.2L Eng VIN D
Compressor Isolation Method: Removal
1977 Dodge and Ram Ram Wagon B300, Van Passenger Extended, 7.2L Eng VIN DSECTION Removal
- Carefully remove service valves from compressor by unscrewing the mounting bolts. Do not disturb line connections and do not turn valve stems with valve assemblies disconnected from compressor (to prevent system discharge). Cap service valves and plug compressor openings to prevent entry of dirt and moisture.
- If compressor clutch is to be removed (for installation on replacement compressor), energize compressor clutch with engine NOT running and remove clutch mounting bolt from end of compressor shaft, then install 5/8-11 bolt in driveshaft hole and tighten bolt to loosen clutch from shaft with clutch energized, disconnect clutch lead. Remove drive belt and clutch.
- Drain and measure compressor oil level. Retain measurement to make proper oil adjustment during installation.
- Remove compressor mounting bolts and lift compressor off engine. Remove clutch field assembly from compressor (on early compressors with rotating field, remove brush assembly).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.