Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM1977PICKUP D200, 2D PICKUP EXTRA CAB, 7.2L ENG VIN DREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEFUEL DELIVERYIDLE ENRICHMENT SYSTEMTESTINGTIME DELAY TEST
1977 Dodge and Ram Pickup D200, 2D Pickup Extra Cab, 7.2L Eng VIN D
Time Delay Test
1977 Dodge and Ram Pickup D200, 2D Pickup Extra Cab, 7.2L Eng VIN DSECTION Time Delay Test
- With ignition switch off, remove wiring connector from time delay solenoid valve. Place a test light across connector terminals.
- Start engine, test light should come on and stay on for approximately 60 seconds after engine starts. If light does not come on or stays on indefinitely, replace timer.NOTE: Test light current draw should not exceed 0.5 amps. as damage to timer may occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.