Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDAIHATSU1990CHARADE L3-0993CC 1.0LREPAIR AND DIAGNOSISCRUISE CONTROLRELAYS AND MODULES - CRUISE CONTROLCRUISE CONTROL MODULETESTING AND INSPECTION
1990 Daihatsu Charade L3-0993cc 1.0L
Cruise Control Module: Testing and Inspection
1990 Daihatsu Charade L3-0993cc 1.0LSECTION Testing and Inspection
Fig. 6 ECU Harness Connector Terminals:
Fig. 7 ECU Diagnosis:
1. Disconnect ECU connector. Using a suitable volt/ohmmeter measure voltage at ECU wire harness side, Fig. 6.
2. Refer to Fig. 7, for procedure. Ignition should be turned off unless otherwise noted.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.