Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY V6-3.6LREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONVERIFICATION TESTSAPS VERIFICATION TEST
2013 Chrysler Town & Country V6-3.6L
APS Verification Test
2013 Chrysler Town & Country V6-3.6LSECTION APS Verification Test
APS VERIFICATION TEST
Diagnostic Test
PERFORM ADJUSTABLE PEDALS SYSTEM VERIFICATION TEST
1. Make sure all accessories are turned off and the battery is fully charged.
2. Connect all previously disconnected components and connectors.
3. If not done previously, turn the ignition on.
4. Using a scan tool, erase all Diagnostic Trouble Codes (DTCs) from all modules.
5. Cycle the ignition from on to off.
6. Turn the ignition on.
7. Operate the Adjustable Pedals in both directions.
8. Press the Adjustable Pedals switch in one direction for at least one second then release the switch. Repeat three times consecutively, but press the switch in the opposite direction each time.
9. Using a scan tool, read DTCs from all modules.
Are any DTCs present or is the original concern still present?
Yes
- Repair is not complete. Refer to appropriate system for the diagnostic procedure.
No
- Repair is complete.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.