Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY V6-3.6LREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONU CODE CHARTSU0209PASSENGER DOOR MODULE (PDM), (DMFL/R)
2013 Chrysler Town & Country V6-3.6L
Passenger Door Module (PDM), (DMFL/R)
2013 Chrysler Town & Country V6-3.6LSECTION Passenger Door Module (PDM), (DMFL/R)
U0209-LOST COMMUNICATION WITH MEMORY SEAT CONTROL MODULE
For a complete wiring diagram, refer to the Wiring Information.
- When Monitored:
Continuously when the ignition is on.
Battery voltage between 10 and 16 volts.
Ignition Off Draw (IOD) fused installed.
Totally Integrated Power Module (TIPM) is configured correctly.
- Set Condition:
Bus messages not received from the Memory Seat Module for approximately two to five seconds.
Diagnostic Test
VERIFY THE DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE
NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.
1. Turn the ignition on.
2. With the scan tool, read the active DTCs.
Is this DTC active?
Yes
- Totally Integrated Power Module (TIPM) and perform the U0209-Lost Communication with Memory Seat Control Module diagnostic procedure.
No
- Manufacturer Code Charts and perform the Stored Lost Communication DTCs diagnostic procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.