Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2013TOWN & COUNTRY TOURING, GASREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSIS3.6L - DTCS P0456 TO P0643
2013 Chrysler Town & Country Touring, Gas
3.6L - DTCS P0456 To P0643
2013 Chrysler Town & Country Touring, GasSECTION 3.6L - DTCS P0456 To P0643
- Diagnosis And Testing
- P0456-EVAP Purge System Small Leak
- P0457-Loose Fuel Cap
- P0461-Fuel Level Sensor 1 Performance
- P0462-Fuel Level Sensor 1 Circuit Low
- P0463-Fuel Level Sensor 1 Circuit High
- P0480-Cooling Fan 1 Control Circuit/Open
- P0501-Vehicle Speed Sensor 1 Performance
- P0503-Vehicle Speed Sensor 1 Erratic
- P0506-Idle Speed Performance Lower Than Excepted
- P0507-Idle Speed Performance Higher Than Excepted
- P050B-Cold Start Ignition Timing Performance
- P0513-Invalid Skim Key
- P0520-Engine Oil Pressure Sensor Circuit
- P0521-Engine Oil Pressure Sensor Performance
- P0522-Oil Pressure Too Low
- P0523-Engine Oil Pressure Sensor Circuit High
- P0532-A/C Pressure Sensor Circuit Low
- P0533-A/C Pressure Sensor Circuit High
- P054A-Cold Start Exhaust Camshaft Position Timing Over-Advanced - Bank 1 Sensor 2
- P054C-Cold Start Exhaust Camshaft Position Timing Over-Advanced - Bank 2 Sensor 2
- P0562-Battery Voltage Low
- P0563-Battery Voltage High
- P0571-Brake Switch 1 Performance
- P0572-Brake Switch 1 Stuck On
- P0573-Brake Switch 1 Stuck Off
- P0579-Speed Control Switch 1 Performance
- P0580-Speed Control Switch 1 Circuit Low
- P0581-Speed Control Switch 1 Circuit High
- P0585-Speed Control Switch 1/2 Correlation
- P0591-Speed Control Switch 2 Performance
- P0592-Speed Control Switch 2 Circuit Low
- P0593-Speed Control Switch 2 Circuit High
- P0600-Serial Communication Link
- P0601-Internal Memory Checksum Invalid
- P0606-Internal ECM Processor
- P060B-Etc A/D Ground Performance
- P060D-Etc Level 2 App Performance
- P060E-Etc Level 2 TPS Performance
- P060F-Etc Level 2 ECT Performance
- P061A-Etc Level 2 Torque Performance
- P061C-Etc Level 2 Rpm Performance
- P0622-Generator Field Control Circuit
- P0627-Fuel Pump Relay Circuit
- P062C-Etc Level 2 Mph Performance
- P0630-VIN Not Programmed In Pcm
- P0632-Odometer Not Programmed In Pcm
- P0633-Skim Secret Key Not Stored In Pcm
- P063A-Generator Voltage Sense Circuit
- P0642-Sensor Reference Voltage 1 Circuit Low
- P0643-Sensor Reference Voltage 1 Circuit High
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.