Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chrysler 300 AWD V8-5.7LFACTORY OEM SERVICE PROCEDURE
Intelligent Battery Sensor (IBS) - Installation
INSTALLATION
NOTE: Connecting the negative battery cable to the Intelligent Battery Sensor (IBS) must be done before installing on the battery post.
1. Connect the negative battery cable to the IBS (1). Tighten to 16 Nm (12 ft. lbs.).
2. Install the IBS on the negative battery post.
3. Tighten the captive nut (3) to 8 Nm (72 In. lbs.).
4. Connect the IBS electrical harness (2) to the IBS.
5. Install the components removed to access the battery Battery - Installation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
