2012 Chrysler 300 AWD V8-5.7LFACTORY OEM SERVICE PROCEDURE

Engine Coolant Temperature Sensor - Removal






5.7L/6.4L

The Engine Coolant Temperature (ECT) sensor is located on the upper portion of the water pump housing. It is installed into a water jacket inline with the thermostat.

Factory service manual diagram




WARNING: Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the coolant temperature sensor.

1. Remove the air intake system Air Cleaner Body - Removal.

NOTE: Do not waste reusable coolant. If solution is clean, drain coolant into a clean container for reuse.

2. Partially drain the cooling system Service and Repair.
3. Disconnect electrical connector (3) from sensor (2).
4. Remove sensor from the water pump housing.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.