Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chrysler 300 AWD V6-3.6LFACTORY OEM SERVICE PROCEDURE
Programming and Relearning
FOBIK PROGRAMMING
FOB with Integrated Key (FOBIK) programming may require the use of the Personal Identification Number PIN) for the vehicle, a diagnostic scan tool and the appropriate diagnostic information. Also be certain that the FOBIK and any replaced electronic modules are programmed in the proper sequence. Testing and Inspection
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.