Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chrysler 300 AWD V6-3.6LFACTORY OEM SERVICE PROCEDURE
Radio Frequency Module (RF Hub) - Installation
INSTALLATION
NOTE: Replace and Program the module(s) per the RF-Hub, BCM, PCM FOBIK and ELV Replacement and Programming Order Guide . RF Hub, BCM, PCM, FOBIK, And ELV Replacement And Programming Order
1. Position into place and install the RF Hub (4) and retainers (1).
2. Connect the electrical connectors (2).
3. If equipped, connect the remote start antenna (3).
4. Install the rear shelf cover Rear Shelf Panel - Installation.
5. Connect the Intelligent Battery Sensor (IBS) to the negative battery post.
NOTE: Program the RF-Hub RF Hub, BCM, PCM, FOBIK, And ELV Replacement And Programming Order
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.