Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chrysler 200 S, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE
Heater, Engine Block: Installation: 2.4L
| 1 - BLOCK HEATER |
| 2 - POWER CORD |
- Thoroughly clean core hole and heater seat.
- Insert heater assembly with element loop positioned upward .
- With heater seated, tighten center screw securely to assure a positive seal.CAUTION:
To prevent damage, the power cord must be secured in it's retaining clips, and not positioned so it could contact linkages or exhaust manifold.
- Connect power cord to heater.
- Lower vehicle.
- Fill cooling system. Refer to STANDARD PROCEDURE .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
