2012 Chrysler 200 Limited, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 3.40 OZS. 0.1 L PAG 46 S
Air Cond Refrigerant 1.00 LBS. 0.45 KG R-134a S
Automatic Transmission Fluid Trans Mfr CD 62TE Overhaul 9.00 QTS. 8.51 L MOPAR Automatic Transmission Fluid Plus 4 or equivalent licensed ATF+4 product Dry fill capacity. Depending on type and size of Internal Cooler, length and inside diameter of Cooler Lines, or use of an Auxiliary Cooler, these figures may vary. S
Automatic Transmission Fluid Trans Mfr CD 62TE Service Fill 5.50 QTS. 5.2 L MOPAR Automatic Transmission Fluid Plus 4 or equivalent licensed ATF+4 product S
Brake Fluid N/A N/A MORAR Brake Fluid DOT 3, SAE J1703 If MOPAR Brake Fluid DOT 3 is not available, then MOPAR Brake and Clutch Fluid DOT 4 is acceptable. S
Engine Coolant 3.6L Eng 11.60 QTS. 10.97 L MOPAR Antifreeze/Coolant 5 Year/100,000 Mile Formula HOAT (Hybrid Organic Additive Technology) or equivalent Includes: heater and coolant recovery tank filled to "max" level. DO NOT mix different types or colors of engine coolant. S
Engine Oil 3.6L Eng w/Filter 6.00 QTS. 5.67 L API - SAE 5W-30 For countries that use the ACEA European Oil Categories for Service Fill Oils, use the recommended engine oil that meets the requirements of ACEA C3, and approved to MB 229.31 or MB 229.51 only. SAE 5W-30 engine oil approved to MB 229.31 or MB 229.51 may be used when SAE 5W-20 engine oil is not available S
Fuel Tank 3.6L Eng 16.90 GALS. 63.97 L S
Power Steering Fluid N/A N/A MOPAR Power Steering Fluid Plus 4 If MOPAR Power Steering Fluid plus 4 is not available, then MOPAR ATF plus 4 Automatic Transmission Fluid is acceptable. S
Windshield Washer Fluid N/A N/A Windshield Antifreeze Not radiator antifreeze. Follow the Manufacturer's Instructions for the mixture ratio. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.