Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chrysler 200 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Power Window Switch: Testing and Inspection
SWITCH - POWER WINDOW
Any diagnosis of the power window system should begin with the use of the scan tool. For information on the use of the scan tool, refer to the appropriate Diagnostic Service Manual.
The diagnosis found here applies only to the driver power window switches. If the problem being diagnosed is an inoperative power window switch illumination lamp, but the power window switch operates as designed, replace the faulty door power window switch.
For complete circuit diagrams, refer to the appropriate wiring information.
1. Disconnect and isolate the battery negative cable.
2. Remove the driver power window switch from the door trim panel. Power Window Switch - Removal.
3. Check the driver door power window switch continuity as shown in the driver power window switch test chart.
DRIVER POWER WINDOW SWITCH TEST - CONVERTIBLE
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
