2012 Chrysler 200 L4-2.4LFACTORY OEM SERVICE PROCEDURE

Cylinder Head Assembly






CYLINDER HEAD

Factory service manual diagram



Factory service manual diagram





If your bolt has the short head, use the following torque specifications:
First: All 30 Nm (25 ft. lbs.)
Second: All 61 Nm (45 ft. lbs.)
Third: All 61 Nm (45 ft. lbs.)
Fourth: All an additional 90°

CAUTION: Do not use a torque wrench for the Fourth step.

If your bolt has the long head, use the following torque specifications:
First: All 30 Nm (25 ft. lbs.)
Second: All 73 Nm (54 ft. lbs.)
Third: All 73 Nm (54 ft. lbs.)
Fourth: All an additional 90°

CAUTION: Do not use a torque wrench for the Fourth step.

HEAD BOLT RE-USABILITY

Factory service manual diagram




The bolts must be examined BEFORE reuse. If the threads are necked down the bolts must be replaced.






SURFACE VARIATION - WARPAGE

Cylinder head must be flat within 0.1 mm (0.004 in.).






CAMSHAFT BEARING CAP

Factory service manual diagram





Install intake and exhaust camshaft bearing caps
Slowly tighten bolts 9.5 Nm (85 in. lbs.)

Factory service manual diagram





Install the front intake and exhaust bearing cap
Tighten bolts 25 Nm (18 ft. lbs.)

INTAKE MANIFOLD
Intake Manifold Specifications

EXHAUST MANIFOLD
Exhaust Manifold Specifications

CAMSHAFT GEAR/SPROCKET
Camshaft Gear/Sprocket Specifications
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.