Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Chrysler 200 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Indicator Based Service
MAINTENANCE SCHEDULES
The engine oil change indicator system will remind you that it is time to take your vehicle in for scheduled maintenance.
On Electronic Vehicle Information Center (EVIC) equipped vehicles, the "Oil Change Required" message will flash in the EVIC display for approximately 3 seconds and a single chime will sound to indicate the next scheduled oil change interval.
On Non-EVIC equipped vehicles, the "Change Oil" message will flash in the instrument cluster odometer for approximately 3 seconds and a single chime will sound to indicate the next scheduled oil change interval.
The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style.
NOTE:
Upon system notification, have your vehicle serviced as soon as possible, particularly within the next 500 miles (805 km).
The oil change indicator system will not monitor the time since the last oil change. Change the engine oil if it has been 6 months since the last oil change even if the oil change indicator message is NOT illuminated.
Change the engine oil more often if you drive your vehicle off-road for an extended period.
Under no circumstances should oil change intervals exceed 6,000 miles (10,000 km) or 6 months, whichever comes first.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.