Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler 300 V6-2.7LFACTORY OEM SERVICE PROCEDURE
Totally Integrated Power Module (TIPM) - Removal
REMOVAL
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. Battery Reconnection .
1. Disconnect and isolate the battery negative cable (2).
2. Open the positive battery cable nut cover to expose nut.
3. Remove the battery cable nut and the battery cable from the Totally Integrated Power Module (TIPM).
4. Disengage the outboard retaining clip, and rotate the TIPM to access wire harness connectors.
5. Disconnect the wire harness connectors from TIPM.
6. Disengage the two inboard retaining clips.
7. Remove the TIPM from vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.