Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler 300 LXFACTORY OEM SERVICE PROCEDURE
Diagnostic Code Index
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| P0562 | BATTERY VOLTAGE LOW - ESM |
| P0562 | BATTERY VOLTAGE LOW - ESM (COLUMN) |
| P0563 | BATTERY VOLTAGE HIGH - ESM |
| P0563 | BATTERY VOLTAGE HIGH - ESM (COLUMN SHIFT) |
| P0607 | ECU INTERNAL PERFORMANCE - ESM |
| P0607 | ECU INTERNAL PERFORMANCE - ESM (COLUMN SHIFT) |
| P0930 | BTSI CONTROL CIRCUIT LOW |
| P0930 | BTSI CONTROL CIRCUIT LOW - COLUMN SHIFT |
| P0931 | BTSI CONTROL CIRCUIT HIGH |
| P0931 | BTSI CONTROL CIRCUIT HIGH - COLUMN SHIFT |
| P2775 | AUTOSTICK UPSHIFT SWITCH CIRCUIT PERFORMANCE |
| P2775 | AUTOSTICK UPSHIFT SWITCH CIRCUIT PERFORMANCE (COLUMN SHIFT) |
| P2779 | AUTOSTICK DOWNSHIFT SWITCH CIRCUIT PERFORMANCE |
| P2779 | AUTOSTICK DOWNSHIFT SWITCH CIRCUIT PERFORMANCE (COLUMN SHIFT) |
| U0002 | CAN C BUS OFF PERFORMANCE - ESM |
| U0002 | CAN C BUS OFF PERFORMANCE - ESM (COLUMN SHIFT) |
| U0100 | LOST COMMUNICATION WITH ECM/PCM - ESM |
| U0100 | LOST COMMUNICATION WITH ECM/PCM - ESM (COLUMN SHIFT) |
| U0121 | LOST COMMUNICATION WITH ANTI-LOCK BRAKE MODULE - ESM |
| U0121 | LOST COMMUNICATION WITH ANTI-LOCK BRAKE MODULE - ESM (COLUMN SHIFT) |
| U0141 | LOST COMMUNICATION WITH FRONT CONTROL MODULE - ESM |
| U0141 | LOST COMMUNICATION WITH FRONT CONTROL MODULE - ESM (COLUMN SHIFT) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.