Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Chrysler 300 LXFACTORY OEM SERVICE PROCEDURE
Electronic Shift Module (ESM) - Electrical Diagnostics
- Diagnostic Code Index
- DTC Troubleshooting
- P0562-Battery Voltage Low - ESM
- P0562-Battery Voltage Low - ESM (Column)
- P0563-Battery Voltage High - ESM
- P0563-Battery Voltage High - ESM (Column Shift)
- P0607-Ecu Internal Performance - ESM
- P0607-Ecu Internal Performance - ESM (Column Shift)
- P0930-BTSI Control Circuit Low
- P0930-BTSI Control Circuit Low - Column Shift
- P0931-BTSI Control Circuit High
- P0931-BTSI Control Circuit High - Column Shift
- P2775-AUTOSTICK Upshift Switch Circuit Performance
- P2775-AUTOSTICK Upshift Switch Circuit Performance (Column Shift)
- P2779-AUTOSTICK Downshift Switch Circuit Performance
- P2779-AUTOSTICK Downshift Switch Circuit Performance (Column Shift)
- U0002-Can C Bus Off Performance - ESM
- U0002-Can C Bus Off Performance - ESM (Column Shift)
- U0100-Lost Communication With ECM/Pcm - ESM
- U0100-Lost Communication With ECM/Pcm - ESM (Column Shift)
- U0121-Lost Communication With Anti-Lock Brake Module - ESM
- U0121-Lost Communication With Anti-Lock Brake Module - ESM (Column Shift)
- U0141-Lost Communication With Front Control Module - ESM
- U0141-Lost Communication With Front Control Module - ESM (Column Shift)
- Standard Procedure
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.