Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Sebring Convertible V6-3.5LFACTORY OEM SERVICE PROCEDURE
System Specifications
3.5L ENGINE
MAIN BEARING CAPS
- The main bearing cap bolts (1) must be tightened in the proper sequence. First the inner main cap bolts, secondly the windage tray bolts, lastly the main cap tie (horizontal) bolts.
- Install the inside main bearing cap bolts and tighten to 20 Nm + 1/4 turn (15 ft. lbs. + 1/4 turn).
- Measure crankshaft end play. Procedures
- Install connecting rods and measure side clearance. Service and Repair
- Install windage tray. Lubricate bolts with engine oil. Finger tighten all bolts first, then tighten to 28 Nm + 90° turn (20 ft. lbs. + 90° turn) beginning with the inside bolts tightening outward.
- Install the main cap tie (horizontal) bolts and tighten to 28 Nm (250 in. lbs.).
CRANKSHAFT PULLEY
Torque bolt to 95 Nm (70 ft. lbs.)
MAIN BEARING CAPS
- The main bearing cap bolts (1) must be tightened in the proper sequence. First the inner main cap bolts, secondly the windage tray bolts, lastly the main cap tie (horizontal) bolts.
- Install the inside main bearing cap bolts and tighten to 20 Nm + 1/4 turn (15 ft. lbs. + 1/4 turn).
- Measure crankshaft end play. Procedures
- Install connecting rods and measure side clearance. Service and Repair
- Install windage tray. Lubricate bolts with engine oil. Finger tighten all bolts first, then tighten to 28 Nm + 90° turn (20 ft. lbs. + 90° turn) beginning with the inside bolts tightening outward.
- Install the main cap tie (horizontal) bolts and tighten to 28 Nm (250 in. lbs.).
CRANKSHAFT PULLEY
Torque bolt to 95 Nm (70 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.