Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Sebring Convertible V6-2.7LFACTORY OEM SERVICE PROCEDURE
Installation
LEFT HAND DRIVE
NOTE: Make sure the remote start antenna is positioned the same way noted during the removal procedure.
1. Install the remote start antenna (2) and screws (1) to instrument panel assembly. Tighten to 2.5 Nm (22 in. lbs.).
2. Route the remote start coaxial cable in the position noted during the removal procedure.
3. Install the coaxial cable mounting clip at the steering column reinforcement bracket.
4. Install the mounting clip (2).
5. Connect remote start antenna coaxial cable connector (1) to skreem module (3).
6. Install instrument cluster.Instrument Cluster - Installation
7. Install radio. Installation
8. Install the instrument panel top pad. Instrument Panel Pad - Installation
9. Connect negative battery cable. Tighten to 5 Nm (45 in. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.