Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Sebring Convertible L4-2.4LFACTORY OEM SERVICE PROCEDURE
Sensor-Engine Coolant Temperature
Component ID: 391
Component : SENSOR-ENGINE COOLANT TEMPERATURE
Connector:
Name : SENSOR-ENGINE COOLANT TEMPERATURE
Color : BLACK
# of pins : 2
Qualifier : (3.5L)
Pin Circuit Description
1 K900 20DB/LB SENSOR GROUND
2 K2 20VT/OR ECT SIGNAL
Component Location - 22
Component Location - 26
Component Location - 27
Component Location - 33
Connector:
Name : SENSOR-ENGINE COOLANT TEMPERATURE
Color :
# of pins : 2
Qualifier : (DIESEL)
Pin Circuit Description
1 K2 20VT/OR ECT SIGNAL
2 K915 20BR/WT SENSOR GROUND
Component Location - 22
Component Location - 26
Component Location - 27
Component Location - 33
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.