Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Sebring Convertible L4-2.4LFACTORY OEM SERVICE PROCEDURE
Variable Induction Control Valve
Component ID: 482
Component : VALVE-MANIFOLD FLOW
Connector:
Name : VALVE-MANIFOLD FLOW
Color :
# of pins : 6
Qualifier : (2.0L/2.4L)
Pin Circuit Description
1 Z902 20BK GROUND
2 - -
3 K601 20BR/VT MFV CONTROL
4 K900 20DB/LB SENSOR GROUND
5 K602 20YL/DB MFV SIGNAL
6 F856 20YL/PK 5 VOLT SUPPLY
Component Location - 29
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
