Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Sebring Convertible L4-2.4LFACTORY OEM SERVICE PROCEDURE
Removal
LEFT HAND DRIVE
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may result in serious or fatal injury.
The remote start antenna is located driver's side front of dash.
1. Disconnect and isolate the battery negative cable.
2. Remove radio. Removal
3. Remove instrument cluster. Instrument Cluster - Removal
4. Remove the instrument panel top pad. Instrument Panel Pad - Removal
NOTE: During removal of the remote start antenna note the routing location of the coaxial cable.
5. Disconnect remote start antenna coaxial cable connector (1) from skreem module (3).
6. Remove the mounting clip (2).
7. Remove the mounting clip at the steering column reinforcement bracket.
8. Remove screws (1) and remove remote start antenna (2) from instrument panel assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
