2008 Chrysler PT Cruiser L4-2.4LFACTORY OEM SERVICE PROCEDURE

Intake Manifold

Upper Intake Manifold

Factory service manual diagram



Plastic Intake Manifold 12 Nm (105 in. lbs.)

Factory service manual diagram



Aluminum Intake Manifold 28 Nm (250 in. lbs.)

Upper Intake Manifold to Cylinder Head support bracket
Cylinder Head fasteners 28 Nm (250 in. lbs.)
Intake Manifold fasteners 6 Nm (55 in. lbs.)

Throttle Cable bracket
Aluminum Intake Manifold 12 Nm (105 in. lbs.)
Plastic Intake Manifold 6 Nm (55 in. lbs.)



Lower Intake Manifold

Factory service manual diagram




Plastic Intake Manifold 12 Nm (105 in. lbs.)


Aluminum Intake Manifold 28 Nm (250 in. lbs.)

Lower Intake Manifold support bracket
Aluminum Intake Manifold 54 Nm (40 ft. lbs.)
Plastic Intake Manifold 6 Nm (55 in. lbs.)


Throttle Body
Throttle Body bolts 12 ±2.25 Nm (105 ±20 in. lbs.)
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.