Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler PT Cruiser L4-2.4LFACTORY OEM SERVICE PROCEDURE
Vehicle Speed Sensor: Locations
Component ID: 341
Component : SENSOR-VEHICLE SPEED
Connector:
Name : SENSOR-VEHICLE SPEED
Color : BLACK
# of pins : 3
Qualifier : (GAS MTX)
Pin Circuit Description
1 K875 20OR/PK VSS 5V SUPPLY
Pin Circuit Description
1 F856 20OR 5 VOLT SUPPLY
2 K975 20BR/OR VSS GROUND
2 K914 20BK/LB SENSOR GROUND 1
3 K75 20WT/OR VEHICLE SPEED SIGNAL
Component Location - 21
Component Location - 25
Component Location - 26
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
