2008 Chrysler PT Cruiser L4-2.4LFACTORY OEM SERVICE PROCEDURE

Removal







REMOVAL

Factory service manual diagram




The valve body assembly must be removed to gain access to and replace the transmission range sensor.

1. Disconnect the battery cables.
2. Remove air cleaner assembly (1).
Factory service manual diagram




3. Remove the battery hold down clamp and remove the battery (1).
Factory service manual diagram




4. Remove the battery tray (1).
Factory service manual diagram




5. Disconnect gearshift cable (1)from manual valve lever(2).
6. Remove manual valve lever.
7. Disconnect transmission range sensor connector.
8. Hoist vehicle.
Factory service manual diagram




9. Remove oil pan bolts (1).
Factory service manual diagram




10. Remove oil pan (1).
Factory service manual diagram




11. Remove oil filter (1).
Factory service manual diagram




12. Remove the valve body-to-transaxle case bolts (1).
Factory service manual diagram




13. Remove park rod rollers (1) from guide bracket (2)and remove valve body from transaxle.
Factory service manual diagram




14.
NOTE: To ease removal of the valve body (1), turn the manual valve lever fully clockwise to low or first gear.

CAUTION: The valve body manual shaft pilot may distort and bind the manual valve if the valve body is mishandled or dropped.

Factory service manual diagram




15. Remove manual shaft seal (2).
Factory service manual diagram




16. Remove TRS retaining screw (3).
Factory service manual diagram




17. Slide Transmission Range Sensor (1) up the manual shaft and remove.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.