Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler PT Cruiser L4-2.4LFACTORY OEM SERVICE PROCEDURE
Transmission Position Sensor/Switch: Locations
Component ID: 340
Component : SENSOR-TRANSMISSION RANGE
Connector:
Name : SENSOR-TRANSMISSION RANGE
Color : DK. GRAY
# of pins : 10
Qualifier : (2.4L)
Pin Circuit Description
1 - -
2 - -
3 T13 18DB/BK SPEED SENSOR GROUND
4 T54 18VT/PK TRANSMISSION TEMPERATURE SIGNAL
5 - -
6 - -
7 T1 18LG/BK TRS T1 SIGNAL
8 T3 18VT TRS T3 SIGNAL
9 T42 18VT/WT TRS T42 SIGNAL
10 T41 18BK/WT TRS T41 SIGNAL
Component Location - 20
Component Location - 23
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
