Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE
Transmission Control Module - Installation
TRANSMISSION CONTROL MODULE - LHD
1. Connect the TCM harness connectors and attach the TCM (2) to the base plate with the two retaining screws (1).
2. Rotate the base plate and install it over the mounting studs on the floor panel.
NOTE: Be sure not to pinch or cause interference with the wiring harnesses while locating the base plate to the floor mounting studs.
3. Install the three plastic retaining nuts (1) and secure the base plate to the vehicle floor.
4. Install the foam insulation panel.
NOTE: Make sure the aligning tabs of the base plate are positioned correctly in the foam insulating panel.
5. Install the carpeting in the passenger footwell.
6. Install the floor mat to the carpet.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.