2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE

Control Module: Locations




Component ID: 346
Component : TRANSMISSION CONTROL MODULE

Connector:
Name : TRANSMISSION CONTROL MODULE C1
Color : BLACK
# of pins : 18
Factory service manual diagram




Pin Circuit Description
1 22DG SCI TRANSMIT
2 - -
3 - -
4 - -
5 - -
6 - -
7 - -
8 - -
9 - -
10 - -
23 - -
24 - -
25 - -
26 - -
27 - -
28 - -
29 18RD/DG TRACTION SYSTEM RELAY OUTPUT
30 18BR GROUND

Component Location - 1
Factory service manual diagram




Component Location - 16
Factory service manual diagram






Connector:
Name : TRANSMISSION CONTROL MODULE C2
Color : BLACK
# of pins : 12
Factory service manual diagram




12 20WT N2 INPUT SPEED SENSOR
13 20BL/DG SENSOR SUPPLY VOLTAGE
14 20GY/RD 1-2/4-5 SOLENOID CONTROL
15 20GY/VT 3-4 SOLENOID CONTROL
16 20GY/DG 2-3 SOLENOID CONTROL
17 20GY/BK TCC SOLENOID CONTROL
33 20BR SENSOR GROUND
34 20BL/YL TEMP SENSOR P/N SWITCH
35 20BK N3 INPUT SPEED SENSOR
36 20DG/YL MODULATION PRESSURE SOLENOID CONTROL
37 20DG SHIFT PRESSURE SOLENOID CONTROL
38 18RD SOLENOID SUPPLY VOLTAGE
H - -
L - -

Component Location - 1
Factory service manual diagram




Component Location - 16
Factory service manual diagram






Connector:
Name : TRANSMISSION CONTROL MODULE C3
Color : BLACK
# of pins : 2
Factory service manual diagram




H 20WT CAN C BUS (+)
L 20DG CAN C BUS (-)

Component Location - 1
Factory service manual diagram




Component Location - 16
Factory service manual diagram






Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.