2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE

Installation







INSTALLATION

Factory service manual diagram




CAUTION: The steering lock and lock cylinder can only be fitted in lock cylinder position "1". Never turn the steering lock when the ignition/starter switch is not fitted.

1. Install the washer (3) and the parking lock valve (4).

NOTE: The ignition switch must not be turned out of position "1" when the ignition/starter switch is not fitted, otherwise the steering lock is locked permanently.

2. Install the ignition switch (2).
3. Install the connector from the ignition/starter switch (1).
4. Install the clamp (9), press in locking pin to install the steering lock (6) to the steering column.
5. Install the warning buzzer contact switch (8).
6. Install the parking lock interlock cable (7).
7. Install the connector from the warning buzzer contact (10).
8. Install the key cylinder.Key/Lock Cylinder - Installation.
9. Install the transponder coil.
10. Install the lower instrument panel cover.Instrument Panel - Removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.