Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE
Oil Pan, Engine
LOWER OIL PAN
Install the lower oil pan and oil pan bolts. Tighten the lower oil pan bolts to 14 Nm (10 ft. lbs.).
UPPER OIL PAN
1. Install the oil pan bolts with the proper size and length bolt in the correct bolt hole.
- (1) M6 X 20
- (2) M6 X 40
- (3) M6 X 90
- (4) M8 X 30
2. Tighten the M6 size bolts to 10 Nm (89 in. lbs). Follow the tightening sequence diagram.
3. Tighten the M8 size bolts to 20 Nm (15 ft. lbs.). Follow the tightening sequence diagram.
Install the lower oil pan and oil pan bolts. Tighten the lower oil pan bolts to 14 Nm (10 ft. lbs.).
UPPER OIL PAN
1. Install the oil pan bolts with the proper size and length bolt in the correct bolt hole.
- (1) M6 X 20
- (2) M6 X 40
- (3) M6 X 90
- (4) M8 X 30
2. Tighten the M6 size bolts to 10 Nm (89 in. lbs). Follow the tightening sequence diagram.
3. Tighten the M8 size bolts to 20 Nm (15 ft. lbs.). Follow the tightening sequence diagram.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.