Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE
Connecting Rod, Engine
ENGINE SPECIFICATION
CONNECTING ROD BOLTS
NOTE: The connecting rod bolts should be examined before reuse. If the threads are necked down, the bolts must be replaced.
1. Examine connecting rod bolts for stretching. Stretching can be checked by holding a scale or straight edge (2) against the threads. If all the threads do not contact the scale (1) the bolt must be replaced.
2. Tighten the connecting rod bolts to specifications.
CONNECTING ROD BEARING CAP TORQUE
Tighten the connecting rod bolts in three stages.
- Stage one, 5 Nm (44 in. lbs.)
- Stage two, 25 Nm (18 ft. lbs.)
- Stage three, rotate bolts 90° clockwise.
CONNECTING ROD BOLTS
NOTE: The connecting rod bolts should be examined before reuse. If the threads are necked down, the bolts must be replaced.
1. Examine connecting rod bolts for stretching. Stretching can be checked by holding a scale or straight edge (2) against the threads. If all the threads do not contact the scale (1) the bolt must be replaced.
2. Tighten the connecting rod bolts to specifications.
CONNECTING ROD BEARING CAP TORQUE
Tighten the connecting rod bolts in three stages.
- Stage one, 5 Nm (44 in. lbs.)
- Stage two, 25 Nm (18 ft. lbs.)
- Stage three, rotate bolts 90° clockwise.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.