Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE
Air Flow Meter/Sensor: Diagrams
Component ID: 203
Component : MAF/IAT SENSOR
Connector:
Name : MAF/IAT SENSOR
Color : WHITE
# of pins : 5
Pin Circuit Description
1 20YL/DG IAT SENSOR SIGNAL
2 20RD/BL FUSED ENGINE CONTROL RELAY OUTPUT
3 20BR SENSOR GROUND
4 20BR/YL 5 VOLT SUPPLY
5 20YL/WT MAF SENSOR SIGNAL
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.