Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE
Accelerator Pedal Position Sensor: Diagrams
Component ID: 4
Component : ACCELERATOR PEDAL POSITION SENSOR
Connector:
Name : ACCELERATOR PEDAL POSITION SENSOR
Color : BLACK
# of pins : 6
Pin Circuit Description
1 20YL/WT ACCELERATOR PEDAL POSITION SENSOR 5 VOLT SUPPLY
2 - -
3 20OR SENSOR GROUND
4 20DG ACCELERATOR PEDAL POSITION SENSOR SIGNAL NO. 2
5 20GY ACCELERATOR PEDAL POSITION SENSOR SIGNAL NO. 1
6 20BK SENSOR GROUND
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.