Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE
Checking Rear Axle Camber
CHECKING REAR AXLE CAMBER
1. Check the vehicle level at the front and rear axles and adjust if necessary. Service and Repair.
2. Check the vehicle level at the front and rear axles with an electronic inclinometer and adjust if necessary. Service and Repair.
3. Check the rear axle camber. (POS+) = Positive Camber, (NEG-) = Negative Camber. Rear Camber specification is -1.13 (+/- 0.5) degrees. The camber on the rear axle is not adjustable. If substantial deviations in the rear axle camber are found, the cause may be one of the following: [1][2]Specifications.
- Too great a difference in the vehicle level between the right and left-hand sides of vehicle.
- Camber strut bent.
- Accident damage to the frame floor. Level differences at the mounting points for the rear axle carrier between the left and right sides of the body. Experience shows that bending caused by an accident also has an effect on the toe.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
