Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE
Operation
OPERATION
Dual zone temperature control provides a side-to-side variation in comfort temperatures to exceed the needs of either front seat occupant.
The A/C Heater Control Module panels are serviced only as complete units and cannot be repaired. If faulty or damaged, the entire A/C Heater Control Module must be replaced.
The A/C Heater Control Module makes it possible to make adjustments coming from the driver such as:
- "Temperature" by setting the temperature thumb-wheels. (2 and 5)
- "Air quantity" by adjusting the blower switch setting. (6)
- "Air distribution" by setting the air distribution switch. (1)
- "Recirculating air" by pressing the recirculating air push-button. (4)
- Activating the residual engine heat utilization system with the ignition switched off by pressing the REST button. (4)
- Switching off the A/C by pressing the EC button (3).
The A/C Heater Control Module integrated in the push-button control module looks after all system regulation and control functions, such as:
- Automatic switch over from fresh air to recirculated air mode.
- Electrical control of the A/C compressor.
- Control of the electric fan for the engine/air conditioning system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
