2008 Chrysler Crossfire V6-3.2LFACTORY OEM SERVICE PROCEDURE

Keyless Entry Transmitter: Specifications







TRANSMITTER

BATTERY TESTING

The batteries in the Remote Keyless Entry Transmitter can be tested by pressing and holding both the lock and unlock buttons simultaneously for more than one second. The batteries are charged sufficiently if the LED next to the ignition key blade lights up briefly.

BATTERY REPLACEMENT

Factory service manual diagram




The transmitter has two 3 volt batteries, which can be removed and replaced without special tools. First, release the key from the closed position; then insert a coin in the side slot of the transmitter and twist. The cover should separate from the body of the transmitter where the batteries are stacked on top of each other. The batteries are available at local retail stores. Recommended replacement batteries are Panasonic(R) CR 2025 lithium or equivalent. Battery life for normal use is about two years.

NOTE: The transmitter MUST be reprogrammed after the batteries are replaced.

TRANSMITTER RANGE

Operation range is within 20 meters (66 feet) of the module/receiver.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.