Fuel Injection: Specifications: Torque

2007 Chrysler Sebring Touring, 2.7 R, Gas/EthanolSECTION Torque
TORQUE SPECIFICATIONS

DESCRIPTION  N.m  Ft. Lbs.  In. Lbs. 
POWER STEERING RESERVOIR PLASTIC MANIFOLD 5.7 - 50
POWER STEERING RESERVOIR ALUMINUM MANIFOLD 11.9 - 105
THROTTLE BODY BOLTS 4-CYLINDER 13.6 - 120
THROTTLE BODY BOLTS 2.7L 13.6 - 120
LOWER SUPPORT BRACKET 2.7L 31.1 23 -
O2 Sensors 41 30 -
The composite manifold uses special plastic screws. The factory installed plastic screws can be removed and installed up to 5 times. Do not exceed the specified torque. These screws must be installed slowly (less than 600 RPMs) to avoid melting the parent material. There are service repair screws available for repair. They require a higher torque than the original screws.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.