2007 Chrysler Crossfire Base, 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Diagnostic Test

  1. 1) CHECK FOR ACTIVE DTC 

    Turn the ignition on.

    With the scan tool, read OCM DTCs.

    Does the scan tool display this DTC as active? 

    Yes 

    1. Replace the Passenger Seat Assembly in accordance with the Service Information.
    2. Perform *AIRBAG VERIFICATION TEST .

    No 

    1. Go to step  2).
  2. 2) VERIFY STORED CODE 

    With the scan tool, erase all OCM DTCs.

    Cycle the ignition off, then back on.

    With the scan tool, read OCM DTCs.

    Does the scan tool display this DTC as stored? 

    Repair  

    1. Replace the Passenger Seat Assembly in accordance with the Service Information.
    2. Perform *AIRBAG VERIFICATION TEST .
Chapter Navigation
Return to Chapter: B1105-Occupant Classification Module Internal- Memory Overflow - OCM
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.