Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2007ASPEN 4.7 P, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISDTCS P0335 TO P0506P0339-CRANKSHAFT POSITION SENSOR INTERMITTENTPOSSIBLE CAUSES
2007 Chrysler Aspen 4.7 P, RWD
Possible Causes
2007 Chrysler Aspen 4.7 P, RWDSECTION Possible Causes
| Possible Causes |
|---|
| (F855) 5-VOLT SUPPLY CIRCUIT OPEN |
| (F855) 5-VOLT SUPPLY CIRCUIT SHORTED TO GROUND |
| (K24) CKP SIGNAL CIRCUIT SHORTED TO VOLTAGE |
| (K24) CKP SIGNAL CIRCUIT OPEN |
| (K24) CKP SIGNAL CIRCUIT SHORTED TO GROUND |
| (K24) CKP SIGNAL CIRCUIT SHORTED TO THE (F855) 5-VOLT SUPPLY CIRCUIT |
| CRANKSHAFT POSITION SENSOR |
| TONE WHEEL/PULSE RING |
| PCM |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.