Installation

2007 Chrysler Aspen 2WD V8-4.7L Flex FuelSECTION Installation





INSTALLATION





1. Before installing ignition switch (1), rotate the slot in the switch to the ON position.

2. Connect the electrical connector to rear of the ignition switch. Make sure that locking tabs are fully seated into wiring connector.

3. Position switch to column and install the mounting screws (2). Tighten screw to 3 Nm (26 in. lbs.).





4. Install the tilt lever bracket (2) mounting screws. Tighten screws to 4.5 Nm (40 in. lbs.).

5. Position the wire retainer into the tilt lever bracket.

6. Reconnect the lower clockspring connectors.





7. Install the steering column opening reinforcement (1).





8. Install the steering column opening cover (2).





9. Install the key cylinder (1) with the key (2) in the cylinder (1).





10. Install steering column upper and lower shrouds (2).

11. Install the tilt lever knob (1).

12. Enable the airbag system.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.