Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2007ASPEN 2WD V8-4.7L FLEX FUELREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIRSWITCH/MODULE - SECOND ROW HEATED SEATREMOVAL
2007 Chrysler Aspen 2WD V8-4.7L Flex Fuel
Removal
2007 Chrysler Aspen 2WD V8-4.7L Flex FuelSECTION Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using an appropriate flat bladed tool, remove the heated seat switch/modules (2) from the rear center floor console (3) by gently prying up from the edge of the switch/module bezel (1). Take care not to scratch or damage the console or bezel in any way.
3. Disconnect the switch/module electrical connectors (2) and (4).
4. Using an appropriate flat bladed tool, remove the heated seat switch/module (3) from the bezel (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.