Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2007ASPEN 2WD V8-4.7L FLEX FUELREPAIR AND DIAGNOSISBODY AND FRAMESEATSSEAT TEMPERATURE CONTROL MODULEDESCRIPTION AND OPERATIONSWITCH/MODULE - SECOND ROW HEATED SEATDESCRIPTION
2007 Chrysler Aspen 2WD V8-4.7L Flex Fuel
Description
2007 Chrysler Aspen 2WD V8-4.7L Flex FuelSECTION Description
DESCRIPTION
Momentary contact push button switch/modules (2) mounted in the front face of the second row center floor console (3) operate the heated second row seat system. Each heated seat switch/module has two Light-Emitting Diode (LED) indicator lamps, which indicate the selected level (Low or High) of the seat heater. Pressing the switch/module button initiates heat. Heat remains on until switched off or until the ignition is turned off. If switched off by the ignition, a switch/module button must be pressed to restart heating.
The switch/modules contain the solid state electronic control and diagnostic logic circuitry for the heated second row seat system. If any of the heated second row seat elements are inoperative or damaged one or more of the LED lamps in the switch/module for the effected seat will flash.
The LED indicator lamps in each heated seat switch/module cannot be repaired. If the LED lamps are inoperative or damaged, or the switch/module is inoperative or damaged the individual heated seat switch/module assembly must be replaced.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.