Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal
2007 Chrysler 300 V6-2.7L VIN RSECTION Removal
REMOVAL
1. Place ignition key in the ACC (2) position.
2. Remove the lower instrument panel trim as necessary to access the park lock cable.
3. Disconnect park lock cable (4) from ignition cylinder (3).
4. Remove the floor console as necessary for access to the park lock cable.
5. If necessary, remove the bolts holding the shield, covering the gearshift and park lock cables, to the floorpan and remove the shield.
6. Disconnect the park lock cable from the shift mechanism. Release retention tab using suitable screwdriver.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.