Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2007300 V6-2.7L VIN RREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSENSORS AND SWITCHES - HVACSOLAR SENSORSERVICE AND REPAIRINSTALLATION
2007 Chrysler 300 V6-2.7L VIN R
Installation
2007 Chrysler 300 V6-2.7L VIN RSECTION Installation
INSTALLATION
1. Position the sun sensor assembly (2) near the instrument panel (3).
2. Connect the wiring harness connector (1) to the sun sensor assembly (2).
3. Align the tab on the sun sensor assembly (1) with the opening in the instrument panel (2).
4. Gently push the sun sensor assembly into the instrument panel until the sensor snap clip retainers (3) are securely engaged.
5. Install the defroster grille.
6. Reconnect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.