Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2007300 V6-2.7L VIN RREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONB CODE CHARTSB1BC7
2007 Chrysler 300 V6-2.7L VIN R
B1BC7
2007 Chrysler 300 V6-2.7L VIN RSECTION B1BC7
B1BC7-DEPLOYMENT DATA RECORD FULL
For a complete wiring diagram Refer to Diagrams/Electrical.
- When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.
- Set Condition:
This DTC will set if the module identifies an out of range internal circuit.
Diagnostic Test
1.CHECK FOR ACTIVE DTC
Turn the ignition on.
With the scan tool, read ORC DTCs.
Is the Deployment Data Record Full DTC active?
Yes
- Go To 2
No
- Perform the *ORC VERIFICATION TEST-VER. 1. Occupant Restraint Controller (ORC) Verification Test
2.REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and personal injury or death.
View repair.
Repair
- Replace the Occupant Restraint Controller.
- Perform the *ORC VERIFICATION TEST-VER 1. Occupant Restraint Controller (ORC) Verification Test
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.