Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Steering Column Fastener Torque
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| DASH SEAL MOUNTING NUTS | 7 | - | 62 |
| GEAR SHIFT LEVER MOUNTING SCREW | 12 | 9 | 106 |
| STEERING COLUMN BRACE MOUNTING SCREW - AT COLUMN | 29 | 21 | 255 |
| STEERING COLUMN BRACE MOUNTING SCREW - AT SUPPORT BEAM | 12 | 9 | 106 |
| STEERING COLUMN LOWER PIVOT BOLT | 30 | 22 | 265 |
| STEERING COLUMN UPPER MOUNTING SCREWS | 30 | 22 | 265 |
| STEERING COUPLING PINCH BOLT - AT GEAR | 54 | 40 | - |
| STEERING COUPLING PINCH BOLT - AT UPPER COUPLING/INTERMEDIATE SHAFT | 31 | 23 | - |
| STEERING INTERMEDIATE SHAFT PINCH BOLT - AT RHD COLUMN | 31 | 23 | - |
| STEERING WHEEL RETAINER BOLT | 70 | 52 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.